How cute is this winter-themed pop-up card? You can use any theme or season for your project. Just follow these step-by-step instructions and create one of your own. This is one that Melissa did recently at Remember This Remember That for her Inter-active/Diorama card class.

You will need the following supplies:
- Paper cutter and Scor-pal
- Bone folder
- Sticky Strip or Scor-tape
- Foam squares (Dimensionals / pop dots)
- Scissors
- Stamps, ink, card stock and patterned paper
- Copics, glitter and ribbon

First, cut card stock - 5-1/2" x 8-1/2" and fold in half for your card. Cut 2 pieces of patterned paper 5-3/8" x 4-1/8", one for the front of your card and one for the inside.

Next cut one piece 5-1/2" x 5" for the stage. On the 5" side score at 1/2", 4" and 4-1/2". Crease well on all score lines.

Stamp, color and cut out all the pieces for your card. Tear three pieces of white card stock for your snow. Glitter all.

Add Scor-tape along 1/2" and 4-1/2" score lines on stage piece.

Leaving wrong side up, align edge of stage to card center, end with single 1/2" score line. Fold other end at 4" score and tuck under, hold in place. Lay out snow man and snow where you want them. Be sure to flip pieces forward to make sure they don't go beyond the front edge of your card. Mark stage with a pencil along bottom of each piece, approximately 1/2" long.



On each of the marks, use your paper cutter or craft knife to cut slots slightly longer than 1/2".
Next remove backing from tape. Fold card stock under at 4" score line. Align other end of stage at center of the card and press to adhere to the card base. Then close the card and press down to adhere tape.


Next cut six 1/2" x 2" pieces of card stock for pop up tabs. Score each one at 1/2". Add adhesive to tabs. Crease well along score line.

Remove backing from adhesive and carefully slip tabs through slots with adhesive facing down and tab pointing towards the card back. Hold card open at 90 degree angle and adhere tab straight up and down to the base of your card.


Attach stamped images and snow banks to tabs using foam squares. You will need to trim down the tabs to fit your snow mounds so that they don't stick up past the edge of your torn edges. Each snow mound will have two tabs and one for the snowman.


Add snow and glitter. Tear and glitter one more piece of card stock for the front of stage.

Add snowflakes to the back of your card. Place a small rhinestone in the center of the large snowflake.

Adhere your ribbon and bow to the front of your card.


Tie on jingle bell and you are done!

For a printer friendly version of this tutorial click the button below.

Have a great weekend and thanks for stopping.
Two Paper Divas - Gayla and Melissa